Ceramic Biddings - Procurement Opportunities

This notice solicits offers for the acquisition and repair of **** units of **** miscellaneous ship and marine equipment. Engineering source approval by the design control activity is required. The approved source retains data rights and manufacturing knowledge essential to maintaining part quality. An alternate source must qualify according to the design control activity's procedures. Award will be made only if the offeror meets qualification requirements at the time of award. The solicitation identifies the office where additional information on qualification requirements can be obtained. The government is not using FAR Part 12 policies for commercial items in this solicitation, but interested parties may express their interest and capability within 15 days of this notice.

The Mobile Area Water and Sewer System (MAWSS) is seeking bids for an annual contract for mechanical joint ductile iron pipe and fittings. The bid opening date is May 16, 2025, at 10:30 AM Central Time. Bids must be submitted in person to the purchasing department bid box at **** Moffett Road, Mobile, AL **** bids must be received no later than the specified time. All bids must be submitted on the attached forms. The successful bidder will be awarded the contract based on total cost and lead time. Additional information is available by contacting Mike Grimes at 251 **** or ***@***. *. * documents are available on the MAWSS website at www. ***. *. *

Lot 1: *** ONLY ONLINE BIDS WILL BE ACCEPTED FOR THIS RFB. *** Emailed and hard copies delivered by any method WILL NOT BE ACCEPTED. On this line, Bidders must enter $ 0. 00 for Contract Amount in the e- procurement system. Actual Contract Amount must be entered on " Official Bid Document" and submitted as an attachment in the e- procurement system. Vendors should review and update, if necessary, all addresses and contact persons for their account prior to bid submission. This information will carry forward to a contract if awarded, therefore please ensure all information is correct. ** Entire Official Bid Document and Bid Bond ( if required) should be combined as one PDF and uploaded** The expansion of the Elizabethtown Community and Technical College Leitchfield campus will construct a new single story, standalone 16, 733 SF building directly west of the current sole campus building. This new facility will house Industrial Maintenance Labs, Nursing and Health Science Labs, new classrooms and an open office administration suite with a workroom and conference room. Exterior wall construction will consist of loadbearing CMU and structural steel on reinforced concrete stem wall and spread footings. Spray foam insulation with brick and metal wall panel comprise the exterior skin of the building. The roof system will be 2- ply SBS roofing over low- slope tapered polyiso insulation board to internal roof drains on level roof structure. Interior walls will be a combination of CMU bearing walls and metal stud with gypsum board. Flooring will be a combination of VCT, sealed concrete and ceramic tile flooring. Ceilings will be primarily acoustic lay- in tiles accented by gypsum board soffits and bulkheads. Heating and cooling are provided by water source heat pumps supported by boilers and a fluid cooler. Ventilation is provided by a dedicated outside air unit. Domestic hot water is provided by a gas water heater.

This is a sources sought notice seeking small business vendors capable of providing condensate pump and seal kits. Respondents must submit their responses via email with the accompanied RFI filled out and sent to the point of contacts listed. The deadline for submission is Thursday, 08 May 2025. The government is only conducting market research and attaining information to identify potential small business contractors. All information provided is strictly voluntary and any pricing provided will not be considered.