Trunk Mat Biddings - Procurement Opportunities

The solicitation is for tree trimming services at the Honolulu Control Facility (HCF). The contractor must furnish all necessary materials, equipment, and services. Specific tasks include trimming various tree types, maintaining clearances, and debris removal. Compliance with OSHA safety requirements is mandatory. Employees must complete security forms, and a list of employees must be submitted within ten days of contract award. The contractor is responsible for protecting existing facilities and repairing any damages caused.

This is a combined synopsis/solicitation for commercial items, issued as a request for quotation (RFQ) for air handling duct cleaning services. The solicitation is a SDVOSB set-aside for a firm-fixed price purchase contract. The response deadline is May 14, 2024, 12:00 PM ET. Offerors must have an active registration in SAM (System for Award Management). Questions must be emailed to ***@***. *. * by 4:00 PM ET, May 9, 2025. The performance period is one base year with four 1-year options to renew, starting June 15, 2025. The place of performance is the Augusta VA Medical Center, Augusta, GA. The statement of work details the scope of work, including system test and balance, and requirements for certified vendors, trained technicians, and documentation. Additional information regarding contract clauses, provisions, and submittal instructions is available in the full solicitation document. Site visits are highly recommended but not mandatory.

This notice is a request for proposal (RFP) for commercial industrial services, specifically safety nets fabrication services, for US Navy ships within a 50-mile radius of San Diego, CA. The contract will be a multiple award, indefinite delivery, indefinite quantity (IDIQ) type contract with five ordering year periods. The procurement is a total small business set-aside, with a NAICS code of **** (ship building and repairing). The award will be based on a best value procurement utilizing past performance, technical, and price as evaluation factors. Offerors must have a Southwest Regional Maintenance Center approved quality system (IAW Navsea Standard Item 009 004) in place at the time of contract award. Interested firms should send an email to the specified addresses to receive a courtesy notification when the RFP is posted.

Lot 1: *** ONLY ONLINE BIDS WILL BE ACCEPTED FOR THIS RFB. *** * On this line, Bidders must enter $ 0. 01 for price and zero ( 0) for delivery in the e- procurement system. * See attached document How to Respond to an Online Bid through the Kentucky Vendor Self Service site ( updated). pdf. * ALL actual BID PRICES and DELIVERY TIME must be entered on attached Bid Sheet and submitted as an attachment in the e- procurement system. * * Please enter contact person, phone number, and email address on the bid sheet. * Emailed and hard copies delivered by any method WILL NOT BE ACCEPTED. Vendors should review and update, if necessary, all addresses and contact persons for their account prior to bid submission. This information will carry forward to a contract if awarded, therefore please ensure all information is correct. ************************************************** Perform Limb Removal ( any size) on standing trees that have been designated and marked for limb removal by the Chief District Engineer or their representative. All limb removal shall comply with the Class II Pruning Standards of the National Arborist Association, Inc. Do not make flush cuts along the trunk, main stem, or main branch of the tree. Make cuts just outside the branch collar. Remove the limbs and all the debris from the site and dispose of the limbs and the debris off of KYTC rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. The Vendor ( Contractor) will be shown the trees designated for limb removal prior to any work being performed. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. The unit of bid for this line item shall be per crew hour. See Terms and Conditions for definition of crew. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsi
Lot 2: Perform Tree Removal on those trees ( 0- 4 inches in diameter) that have been designated and marked for cutting and removal by the Chief District Engineer or their representative. Cut all trees to within three ( 3) inches of the ground line. Remove the trees and all the debris from the site and dispose of the trees and the debris off of the rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. Perform Stump Treatment as incidental to this item of work. Application of herbicide stump treatment shall be made within one hour upon cutting of tree. The size of the trees will be determined by the average diameter of the tree trunk taken at a point measured two ( 2) feet above the base of the tree at the ground line. The diameter will be measured to the nearest full inch. Trees will be measured prior to any cutting and removal. The Vendor ( Contractor) will be shown the trees to be cut prior to any work being performed. At this time, any disagreements by the Contractor as to the size of the trees will be resolved with the personnel from the Department of Highways who are responsible for determining Tree Removal work. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. The unit of bid for this line item shall be per crew hour. See Terms and Conditions for definition of crew. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsive. Bidder does not have to bid all districts.
Lot 3: Perform Tree Removal on those trees ( 5- 12 inches in diameter) that have been designated and marked for cutting and removal by the Chief District Engineer or their representative. Cut all trees to within three ( 3) inches of the ground line. Remove the trees and all the debris from the site and dispose of the trees and the debris off of the rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. Perform Stump Treatment as incidental to this item of work. Application of herbicide stump treatment shall be made within one hour upon cutting of tree. The size of the trees will be determined by the average diameter of the tree trunk taken at a point measured two ( 2) feet above the base of the tree at the ground line. The diameter will be measured to the nearest full inch. Trees will be measured prior to any cutting and removal. The Vendor ( Contractor) will be shown the trees to be cut prior to any work being performed. At this time, any disagreements by the Contractor as to the size of the trees will be resolved with the personnel from the Department of Highways who are responsible for determining Tree Removal work. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsive. Bidder does not have to bid all districts.
Lot 4: Perform Tree Removal on those trees ( 13- 20 inches in diameter) that have been designated and marked for cutting and removal by the Chief District Engineer or their representative. Cut all trees to within three ( 3) inches of the ground line. Remove the trees and all the debris from the site and dispose of the trees and the debris off of the rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. Perform Stump Treatment as incidental to this item of work. Application of herbicide stump treatment shall be made within one hour upon cutting of tree. The size of the trees will be determined by the average diameter of the tree trunk taken at a point measured two ( 2) feet above the base of the tree at the ground line. The diameter will be measured to the nearest full inch. Trees will be measured prior to any cutting and removal. The Vendor ( Contractor) will be shown the trees to be cut prior to any work being performed. At this time, any disagreements by the Contractor as to the size of the trees will be resolved with the personnel from the Department of Highways who are responsible for determining Tree Removal work. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsive. Bidder does not have to bid all districts.
Lot 5: Perform Tree Removal on those trees ( 21- 30 inches in diameter) that have been designated and marked for cutting and removal by the Chief District Engineer or their representative. Cut all trees to within three ( 3) inches of the ground line. Remove the trees and all the debris from the site and dispose of the trees and the debris off of the rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. Perform Stump Treatment as incidental to this item of work. Application of herbicide stump treatment shall be made within one hour upon cutting of tree. The size of the trees will be determined by the average diameter of the tree trunk taken at a point measured two ( 2) feet above the base of the tree at the ground line. The diameter will be measured to the nearest full inch. Trees will be measured prior to any cutting and removal. The Vendor ( Contractor) will be shown the trees to be cut prior to any work being performed. At this time, any disagreements by the Contractor as to the size of the trees will be resolved with the personnel from the Department of Highways who are responsible for determining Tree Removal work. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsive. Bidder does not have to bid all districts.
Lot 6: Perform Tree Removal on those trees ( 31- 40 inches in diameter) that have been designated and marked for cutting and removal by the Chief District Engineer or their representative. Cut all trees to within three ( 3) inches of the ground line. Remove the trees and all the debris from the site and dispose of the trees and the debris off of the rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. Perform Stump Treatment as incidental to this item of work. Application of herbicide stump treatment shall be made within one hour upon cutting of tree. The size of the trees will be determined by the average diameter of the tree trunk taken at a point measured two ( 2) feet above the base of the tree at the ground line. The diameter will be measured to the nearest full inch. Trees will be measured prior to any cutting and removal. The Vendor ( Contractor) will be shown the trees to be cut prior to any work being performed. At this time, any disagreements by the Contractor as to the size of the trees will be resolved with the personnel from the Department of Highways who are responsible for determining Tree Removal work. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsive. Bidder does not have to bid all districts.
Lot 7: Perform Tree Removal on those trees ( 41- 60 inches in diameter) that have been designated and marked for cutting and removal by the Chief District Engineer or their representative. Cut all trees to within three ( 3) inches of the ground line. Remove the trees and all the debris from the site and dispose of the trees and the debris off of the rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. Perform Stump Treatment as incidental to this item of work. Application of herbicide stump treatment shall be made within one hour upon cutting of tree. The size of the trees will be determined by the average diameter of the tree trunk taken at a point measured two ( 2) feet above the base of the tree at the ground line. The diameter will be measured to the nearest full inch. Trees will be measured prior to any cutting and removal. The Vendor ( Contractor) will be shown the trees to be cut prior to any work being performed. At this time, any disagreements by the Contractor as to the size of the trees will be resolved with the personnel from the Department of Highways who are responsible for determining Tree Removal work. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsive. Bidder does not have to bid all districts.
Lot 8: Perform Tree Removal on those trees ( 61 inches and above in diameter) that have been designated and marked for cutting and removal by the Chief District Engineer or their representative. Cut all trees to within three ( 3) inches of the ground line. Remove the trees and all the debris from the site and dispose of the trees and the debris off of the rights- of- ways. Keep the premises free from the accumulation of waste material and debris at all times. At the completion of the work, remove all debris and waste material from the site and dispose of the debris and waste material off of the rights- of- ways. Perform Stump Treatment as incidental to this item of work. Application of herbicide stump treatment shall be made within one hour upon cutting of tree. The size of the trees will be determined by the average diameter of the tree trunk taken at a point measured two ( 2) feet above the base of the tree at the ground line. The diameter will be measured to the nearest full inch. Trees will be measured prior to any cutting and removal. The Vendor ( Contractor) will be shown the trees to be cut prior to any work being performed. At this time, any disagreements by the Contractor as to the size of the trees will be resolved with the personnel from the Department of Highways who are responsible for determining Tree Removal work. Perform necessary Maintain and Control Traffic work items as outlined in the Terms and Conditions. Bidder must submit bid for all line items for bid within a selected KYTC District to be considered responsive. Bidder does not have to bid all districts.