Louvers Government Bids & RFPs

The U. S. Army Corps of Engineers, Pittsburgh District, is seeking electrical services under a Blanket Purchase Agreement (BPA) for various facilities in Pennsylvania, Ohio, and West Virginia. The BPA aims for a cost-effective, rapid response method for maintaining facilities. The work includes emergency support, maintenance, repair, installation, and upgrades for commercial and industrial systems. The duration of this blanket purchase agreement shall be three 3 years, or upon reaching the bpa expiration. The contractor shall furnish all labor, specialty equipment, and materials necessary to execute the services for each bpa call under this agreement.

The bid notice states that quotes are due on February 16, 2026, at 4:00 PM CT. Site visits are scheduled for January 22, 2026, and January 30, 2026, at 10:00 AM CT. Questions are due by February 2, 2026, at 4:00 PM CT.

The contractor must provide a conceptual package including a construction schedule, project submittals, and complete necessary permits. The project involves removing and replacing air inlet louvers and frames on three cooling towers. The design and installation must comply with specific codes and standards. The contractor must submit a schedule of work, schedule a preconstruction conference, and perform a prework inspection. Working hours are Monday to Friday, 8:00 a. m. to 5:00 p. m. The contractor must provide a warranty certificate for products with a warranty of two or more years. The contractor must provide written notification to the contracting officer two weeks prior to the commencement of work. The contractor must maintain a safe work area and remove all construction rubble. SDSS, proposed container sizes and rates of use must be submitted to the fort yuma safety officer via the co for review and approval at least 15 duty days prior to any materials being brought onto any portion of the installation. The contractor is required to have and maintain material safety data sheets sdss on all materials that are used. The contractor is responsible for training his employees to properly use any authorized hazardous materials and properly handle hazardous wastes. A monthly chemical usage report will be submitted to the fort yuma safety officer via the cor that lists the amount of materials with associated sdss used and locations of usage. After completion of the project, a final total chemical usage report will be submitted to the fort yuma safety officer via the cor that lists the amount of materials with associated sdss used and locations of usage. All contractorgenerated hazardous waste will be removed from the base the same day it is generated, and disposed of offsite. The contractor is responsible for all hazardous waste characterization and proper disposal. The contractor shall be knowledgeable of, and comply with all applicable federal, state, and local regulations and requirements regarding environmental protection. The contractor is solely responsible for compliance with em **** safety health requirements manual and osha standards for the protection of their employees. The contract manager shall ensure specific safety requirements in the indian health manual ihm standards are complied with by contractor personnel when noncompliance would clearly present the potential to harm or damage government resources. The contractor shall complete and follow all instructions on fycc policy for hot work procedures. The contractor shall provide and maintain all temporary facilities required for execution of the work. The contractor shall control dust, noise, and debris to minimize impact on adjacent operations and personnel. In patientcare and occupied areas, contractor shall install airtight dust barriers. Noisy operations shall be scheduled outside of patient rest hours whenever feasible, and advance notice shall be given to the cor. Demolition includes removing existing air inlet louver frames and louver packs. Disposal of all louvers, frames, and debris offsite per federal, state, and local regulations. Protection of cooling tower casings, basins, fans, and adjacent equipment during demolition. Provide new stainless steel air inlet louver frames sized to match existing tower openings. Install frames square and level. Fasten per manufacturer requirements to resist vibration, wind load, and water spray. Coat and protect all field cuts, welds, or fasteners to prevent corrosion. Install new louver packs into the stainlesssteel frames for all three cooling towers. Ensure louvers are seated, secured, and aligned to provide proper airflow and water shedding. Seal all joints between frames and tower walls to prevent bypass air and water leaks. Return all cooling towers to full operation after installation of louvers. Verify cooling tower airflow and performance after installation. Provide adjustments as needed to restore design operatio