BidHits™ uses cookies to provide an individualized service and care for the privacy and protection of shared data.
By browsing this site, we understand that you agree to the terms of our Privacy Policy.
Fatigue Test Stand Spindles - SOLE SOURCE TO GOODRICH CORPORATION The 309th MXSS has a sole source requirement for the procurement of Cyclic Endurance Test Spindles for Power Take- Off ( PTO) Shaft Cyclic Endurance Test Stand ****- 95B. Part Number D
Cyclic endurance test spindles **** new custom test spindle ( 3 each), **** new custom test spindle ( 2 each), **** new custom test spindle ( 1 each)
AI helper
The 309th MXSS has a sole source requirement for cyclic endurance test spindles for a PTO shaft cyclic endurance test stand. The contractor must deliver the equipment to Hill Air Force Base. A standard commercial warranty is required.
The contractor shall provide a standard commercial warranty.
High Speed Aerial Targets ( HSAT) HSAT Target 1: Minimum 30 mins endurance at 15, 000 ft, airspeed 250- 500 ktas, 100 lbs internal payload, 100 lbs wing payload, operates day/night VMC/IMC, launch wind 25 knots, land launch, parachute recovery, sustained positive G at 10, 000 ft of 4. 0, operating altitude 50 ft AGL to 40, 000 ft MSL. HSAT Target 2: Minimum 30 mins endurance at 15, 000 ft, airspeed 150- 350 ktas, 15 lbs internal payload, 15 lbs wing payload, operates day/night VMC/IMC, launch wind 15 knots, land launch, parachute recovery, sustained positive G at 10, 000 ft of 3. 0, operating altitude 50 ft AGL to 30, 000 ft MSL. Both targets require TRL 6 minimum, acoustic and scalar scoring, IFF modes 3A and 3C, and must be parachute recoverable on land and in water.
AI helper
The U. S. Army is conducting market research for High Speed Aerial Targets (HSAT) to test and evaluate surface-to-air defense weapons systems. Two target types are described with specific performance requirements for endurance, airspeed, payload, operating environment, launch, recovery, G-force, and altitude. Potential sources must demonstrate capability to provide targets, ground control systems, payloads, scoring systems, IFF modes, and support equipment. Depot-level supply, repair, maintenance, operations manuals, and training are also required. Delivery of a complete, operationally-ready system is expected within 12 months of award, with estimated annual production rates of 15 for HSAT Target 1 and 30 for HSAT Target 2. Responses are due by 2:00 PM EST on January 1, 2026. This is a Sources Sought Notice, not a Request for Proposal.
Potential sources must be able to deliver a complete, operationally-ready subscale target system within 12 months after award. potential source must be able to deliver a complete, operationally-ready subscale target system including but not limited to targets, om manuals, support equipment, training, spares, contractor depot-level repair maintenance capability within 12 months after award
Targets are required to be at a minimum of Technology Readiness Level 6. argets are required to be at a minimum of technology readiness level 6.
United States Special Operations Command ( USSOCOM) Long Range/Long Endurance ( LR LE) Uncrewed Aerial System ( UAS) Event 2027- 1 ( sLE27- 1) - 1. General: This Request for Information ( RFI) is not a solicitation for proposals, proposal abstracts, quotations, or obligation on the part of the Government to acquire any products or services, but for planning purposes only. T
unmanned aircraft drones
AI helper
This is a Request for Information (RFI) for long-range, long-endurance uncrewed aerial systems (UAS) to gain knowledge of potential qualified sources and explore industry capabilities. The US Special Operations Command (USSOCOM) is seeking information on specific technology areas. Responses are for planning purposes only and do not obligate the government to acquire any products or services. Interested parties must submit a 3-5 page unclassified capability paper by June 5, 2026, through the USSOCOM Vulcan platform. Vendor presentations are scheduled for July ****, 2026. Technical evaluation invitations will be sent by July 30, 2026, with device delivery by August 31, 2026. Technical evaluation training will occur September 7-11, 2026, followed by the technical evaluation from September 12 to October 16, 2026. Operational Test and Evaluation (OT&E) is scheduled from January 11 to February 1, 2027. All equipment returned by February 15, 2027. Questions regarding the Vulcan platform can be sent to ***@***. *. * other questions must be emailed to socom. sofatl. tis. rc. sums. dl@socom. mil.
The deadline for RFI responses is not later than June 5, 2026. Device delivery for technical assessment is due by August 31, 2026. All manufacturer vendor equipment is to be returned by February 15, 2027. The bid notice states lt 5 june 2026 rfi response and 31 august 2026 device delivery and lt 15 february 2027 device return.
The bid notice states proceeding to the next portion is based solely upon best agency need and requirements.
The bid notice states interested parties are responsible for adequately marked proprietary or competition sensitive information contained in their response. and all hardware equipment submitted for the evaluation shall be production models and capable of performing specific core mission sets conducted by special operations forces sof uas operators in an operational environment.
The bid notice states sums air program will request a minimum of five 5 complete systems for the duration of the events with a designated device delivery date. and manufacturers vendors deliver on loan fully functional devices and associated items for technical assessment.
United States Special Operations Command ( USSOCOM) small Uncrewed Multidomain Systems ( sUMS) Medium Range/Medium Endurance ( MR/ME) Event 2026 - 1. General: This Request for Information ( RFI) is not a solicitation for proposals, proposal abstracts, quotations, or obligation on the part of the Government to acquire any products or services, but for planning purposes only. T
Request for Information ( RFI) for Medium Range Medium Endurance ( MR/ME) Uncrewed Aerial Systems ( UAS)
AI helper
This is a Request for Information (RFI) for Medium Range Medium Endurance (MR/ME) Uncrewed Aerial Systems (UAS). The RFI is for planning purposes only and does not constitute a solicitation. Responses are due by December 11, 2025, via the USSOCOM Vulcan platform. Vendor presentations are scheduled for December 18, 2025, at SOFWERX in Tampa, Florida. Technical evaluations and operational testing will follow in 2026. The government assumes no financial responsibility for any costs incurred.
The device delivery deadline is February 10, 2026. Manufacturers vendors deliver on loan fully functional devices and associated items for technical assessment at a location to be determined later.
The RFI seeks information on potential qualified sources and to explore industry capabilities. his rfi is to gain knowledge of potential qualified sources and to explore industry capabilities.
The RFI requires the submission of devices for evaluation. manufacturers vendors deliver on loan fully functional devices and associated items for technical assessment at a location to be determined later.
SUPPRESSOR TESTING - DPS is seeking participation in suppressor testing. Refer to the Suppressor Testing Protocols and Suppressor Requirements and Specifications exhibits for more information. Vendors must return signed solicitation by 9/26/2025 to participate.
Suppressor testing protocols three 3 suppressors with quick mounting systems, all supporting documents required in phase I
AI helper
Bidders must submit three suppressors with quick mounting systems and all supporting documents required in Phase I to the Texas Department of Public Safety Tactical Training Center Firearms Training Unit by September 26, 2025. The suppressors must be delivered by October 27, 2025. The suppressors must be representative of current production models and show no appreciable wear. The Texas Department of Public Safety reserves the right to reject any submissions that have been altered. Bidders must be prepared to present a shooting team for endurance and accuracy tests. Expenses for travel, lodging, meals, and incidental expenses for the shooting team are the responsibility of the bidders. The testing will be conducted in four phases. Phase I includes examination, verification of manufacturer's certifications, comprehensive inspection, and sound propagation analysis. Phase II involves an endurance functional reliability test. Phase III is sustained quality assurance testing. Bidders must execute a release of liability prior to commencement of the test procedure.
The three suppressors must be delivered on or before October 27, 2025.
The documentation accompanying the bidder's submission must include all warranties applicable to the suppressor, including the muzzle device.
Any submission not conforming to the required specifications during Phase I will be deemed unacceptable and will no longer be eligible for testing. Any failure will result in all three submissions being disqualified from testing.
Three suppressors with quick mounting systems are required.
Add keywords for your products or services. Smart Search helps catch related opportunities beyond exact matches.
2
Start the trial and receive alerts
Use the 14-day free trial and get email alerts with documents or official posting links.
3
Tune your feed
Adjust keywords, regions, email schedule and email style. Use map view and filters when you want to explore.
What our users say
All bids related to our product are captured by you and sent to us. In my opinion, it’s perfect—broad coverage and easy searches across the bid documents.
R. M. Ferreira
They deliver on their promises. The information is simple and straightforward.
G. G
They provide information on a wide and varied range of purchasing processes. All the necessary details are also included.
J. M. Defelitto
I closed deals thanks to the information gathered by the search tool. There’s no need to research across multiple media outlets.
J. Comunale
Very good and accurate information about the tenders: consistent and precise.
We selected the most helpful reviews from real users. Order may change periodically.
Excellent information. Just what I was looking for.
L. H. Borrelli
The information helps me submit my bids on time for bids, and I also have readily available information on upcoming bids. So far, I am very satisfied with what I have received.
M. A. Z. Armenta
The idea of ​​using a keyword and sending the information by email is very good.
U. Solutions
I consistently received notifications about bids within the specific segment I chose to monitor. The system simplifies processes that used to be complex, offering a navigation experience that is easy, fast, and modern.
G. P. da S. E. Guimaraes
It is complete and optimal, it improves my time.
R. de L. Cruz
The tool is truly effective at scanning bid documents, efficiently delivering bids.
G. D. Reis
You see a lot of tenders; you get emails with the alerts.
M. Camarasa
Practicality, speed, trust, and credibility—that’s what the work conveys. The information is precise and sharply targeted.
N. De Lima
Excellent platform to help promote and expand the reach of your work.
C. Merino
I like the way they provide information with the greatest possible accuracy. I love that.
M. A. Neil
It encompasses all portals in one place.
G. Ferrea
The platform is very user-friendly.
N. Lobato
The email alert is amazing. I really liked the speed — the bid notices arrive by keywords directly in my inbox, which makes searching much easier. I only need to focus on the other processes, which is a big relief.
BidHits is a government bid search engine that monitors official portals and brings relevant federal, state and local opportunities into one place. You can search on the site and receive scheduled email alerts.
Enter your email and activate the trial. For 14 days you can use the main features, including alerts and access to results. When it ends, if you do not subscribe at /subscription.php, the bid list becomes limited and you will not be charged automatically.
1) Add keywords that describe what you sell. 2) Start the trial. 3) Adjust regions, delivery times and email style after signup.
Whenever possible, yes. Some official portals require login or block direct links; in those cases we point you to the official process page so you can download the documents.
Yes. You can filter by region, procurement method, dates and value ranges. You can also save preferences for future alerts and searches.
Yes. In the dashboard you can see bids on a map and use it to plan follow-up by location.
It can happen. Smart Search uses your keywords to find related opportunities, not only exact matches. Add specific terms and remove off-topic results to improve future alerts.
Yes. You can query bids via API. Documentation at /api_integration.php. Ideal for CRM, BI and automations.
In Settings you can pause alerts or adjust delivery times. If you want to delete your account, just contact us. During the free trial there is no auto-charge.
We monitor major official sources every day at the federal, state and local levels. New bid notices are added as soon as they are captured from the source portal.
Plans start at $ 43.00 per month, with options for different business needs and billing terms. Start with a free trial and evaluate the results before subscribing, with no automatic billing.
Add what you sell, get scheduled alerts, open documents or the official page, and use filters by region and method.
Transcript
Welcome to BidHits.
Finding public tenders and bids is important. But what really matters is quickly identifying the opportunities that match what your company sells.
To get started, enter a few keywords that describe your products or services. BidHits shows relevant opportunities, highlights your keywords, and organizes everything by date.
Smart search is already enabled and uses artificial intelligence to expand your results, even when the tender uses different words from the ones you searched for.
For each opportunity, you can view a summary, access documents, mark it as a favorite, add private notes, remove what is not relevant, or view it on the map.
You can also use filters, run searches, and explore the day's opportunities directly on the map.
Start using BidHits now. It's fast, practical, and you can try it for free.
AI Assistant
Ask me about the bid...
Loading summary...
Methodology
Unaided survey with 1096 active users, conducted through 09/16/2026.
Single question: "Would you recommend our services to a friend or colleague?" - 90% answered "yes".
™
