The
plans for the renovation of classrooms at Lewis Clark State College's Sam Glenn Complex, including mechanical, plumbing, and electrical upgrades, have been approved by the Idaho Division of Occupational and Professional Licenses (DOPL). The approval is contingent on compliance with the markups and notes applied. Construction safeguards are required for demolition and construction activities. A sprinkler evaluation by a licensed sprinkler contractor is required for tenant renovations and reconfigurations. The project includes several alternates, such as custom student work benches and cabinets. Additional documents, including plan review notes and approved stamped
plans, must be on-site during inspections. The project description includes the scope of work, including new finishes on the floor, ceiling, and walls, and small amounts of demolition. The project will not involve life safety or structural alterations. The notice also includes detailed specifications, abbreviations, symbol legends, project notes, means of egress, occupancy calculations, and graphic scales. There are specific requirements for materials, finishes, and existing work removal and replacement. The notice also includes information about acceptable light gauge metal framing manufacturers, slotted track, fastenings, deflection, anchorage, blocking, backing plates, sound rated assemblies, bracing, wall finishes, framing spacing, height, span limitations, typical nonload bearing wall details, top of full height walls, partial height walls, lateral loads, cutting, patching, refinishing, existing surfaces, removal, relocation, extension, abandoned pipe, ducts, conduits, equipment, hazardous materials, temporary dustproof partitions, rotted wood, corroded metals, deteriorated masonry, concrete replacement, relocate items, new surface finishes, new construction, existing work, hvac, plumbing, fire protection, electrical, telecommunications, services, abandoned pipe, ducts, conduits, equipment, cap stub, identification, patching, cutting, matching, testing, defective work, refinishing, continuous surfaces, assembly, color, texture, appearance, substrate, defects, condition, substrate, repairing, finish, exposed work, recovering, refinishing, matching, rooms, spaces, refinishing, visible surfaces, specified condition, adjacent finishes, neat transition, change of plane, existing work, float, neat, smooth transition, ceiling types, ceiling height, ceiling fixture legend, recessed led light fixture, return air diffuser exhaust, supply air diffuser, existing sprinkler head, masonry wall, concrete wall, load bearing wall, nonload bearing partition, acoustical core thickness, core height, wall termination, full height, low wall height, fire rating, smoke structure, thicknesses, concrete masonry, metal studs, wood studs, shaft, studs, nonload bearing partition types, configurations, termination, profiles, wall finishes, framing members, minimums, height, span limitations, typical nonload bearing wall details, blocking, backing plates, products, toilet, bath accessories, plumbing, electrical fixtures, casework, handrails, equipment, furnishings, top of full height walls, deflection, partial height walls, bracing, lateral loads, sound rated assemblies, listed assemblies, light gauge metal framing manufacturers, slotted track, fastenings, deflection, outer track, main structure, manufacturers, icc evaluation report, number, cut stud, short, clark, dietrich, ****, marinoware, ****, equal, design gap, fasten, slotted track, deep leg, nested, cemco, metal framing, ****, cripple stud, certified steel stud association, cssa, ****, stud, screw, inner track, tighten, framing screws, track piece, jamb, jamb, manufacturers, icc evaluation report, published height limitation tables, minimum stud sizes, increased size, published tables, icc evaluation report, studs, corners, abutting construction.